1. Use:

A single group of silicone glass glue can be used immediately. It is easy to type it from the bottle with a glue gun, and can be used to repair the surface with a spatula or wood chip.

2. Sticky time:

Solidification process of silicone rubber is from the surface to inner development, the different characteristics of the silicone table dry time and curing time is different, so if you want to repair surface must be conducted before the glass glue dry table (acid gel, neutral cellophane tape shall generally be in 5 to 10 minutes, neutral mixed glue shall generally be in 30 minutes). If the color paper is used to cover a certain place, after coating, must be removed before the skin is formed.

3. Curing time:

Glass adhesive curing time is as the adhesive thickness increases, such as 12 mm thickness of acidity glass glue, may take 3 to 4 days can be solidified, but about 24 hours, have 3 mm outer layer has formed. When glued to glass, metal or most wood, it is 20 pounds/inch at room temperature after 72 hours.

If the use of glass glue is partially or completely closed, the curing time is determined by the closeness of the airtight. In a place of absolute closeness, it is possible to remain uncured forever. If the temperature is raised, the glass will soften. The gap between metal and metal bonding should not exceed 25mm. In all kinds of bonding situations, including airtight conditions, the adhesion effect should be thoroughly checked before the equipment is used.

In the curing process, acid glass glue will produce a smell because of the volatilization of acetic acid, which will disappear in the curing process and will not smell after curing.

4. Bonding:

A. Wipe the surface of the metal and plastic completely, remove the oil, and then remove the entire surface with acetone, and then rub the surface of the rubber surface with sand paper and then rub it with acetone. Please observe the precautions when using acetone.

B. glass glue evenly coated on the surface of the object that is ready, if is two surface bonding, can put a look for the position, the other side extrusion with enough force to squeeze out the air, but be careful not to squeeze out the glass glue.

C. Place the adhesive device at room temperature and treat the glass to solidify.

5. Seal: the silicone glass sealant is used for sealing, and the glass glue is pressed into the joint surface or gap in the same way, so that the glass glue is fully exposed to the surface.

6. Cleaning: before curing, the glass glue can be wiped off with a cloth or paper towel. After curing, it should be cleaned with a scraper or xylene, acetone and other solvents.

2018-04-26