1.Firstly , prepare the necessary tool ,wood board, knives, scissors, funnel , etc.

2.Fix the original mold on the wood board. Then roll the clay out. Use the clay to enclose the wood board.      The thickness of the clay should be uniform. Then use the clay to enclose the original mold. The clay        must be close to the mold. Make the surface of the clay to be smooth, it will be much easier to demold      Make two clay pillar, one for pouring the silicone rubber, the other for releasing the bubbles.

3.Use the paper board to enclose the original mold Brush a layer of release agent on the clay. Take enough    gypsum into the bucket(the mixing ratio of gypsum and water is about 1:1), then stir it evenly. Pour the      mixture into the square.

4.Remove the paperboard when the gypsum is cured, trim edge of the gypsum mold. Brush a layer of            release agent on the gypsum mold for demolding easily. Clean up the clay and close the gypsum mold

5.Here we use silicone rubber, adding 2%-5% curing agent into the silicone rubber, then stir the silicone        rubber and curing agent evenly.

 6.Vacuum to -0.1MP, which can release bubbles. Then pour the silicone rubber into the gypsum mold.          Remove the gypsum mold when the silicone rubber is cured.

 7.Then check and trim the silicone mold with scissors. The silicone mold for candle is finished. We              suggest to put the silicone mold into production after 24 hours.

 

 

 

 

 

 

 

 

 

 

 

2016-12-20